We will reply to your message within an hour.
More
An economical alternative to standard unthreaded spacers.
Compared to our general purpose washers, these have exaggerated diameters and/or thicknesses for covering oversized holes or for use as spacers and levelers.
Use these metric washers to evenly distribute the load under bolt or screw heads and nuts when fastening. They can also act as spacers.
SAE washers generally have a smaller ID and OD than USS washers.
Also known as Type B washers, ASME washers are available in narrower and wider diameters than SAE and USS washers.
USS washers generally have a larger ID and OD than SAE washers.
Designed for use with structural screws, studs, and nuts, these washers are often used for construction and exterior building applications.
When you’ve applied the correct tension, these washers release an orange dye as a visual indicator.
These thick washers are designed to support structural screws, studs, and nuts.
Square washers fit into slots and channels and have flat sides to keep them from rotating.
Prevent screws from sinking into wood—these washers have a large OD.
Connect cross-bracing rods or cables to structural beams.
These washers have a flange to spread force across structural beams better than standard washers for cross-bracing rods and cables.
Repair sagging, cracked plaster with these washers. The holes allow plaster to flow through to form a secure bond between the washer and the wall.
These washers have prongs that pierce foam insulation so they stay in place.
As a screw is tightened, these washers flatten to add tension to the joint, counteracting fatigue around the joint from small amounts of vibration.
As a screw is tightened, these metric washers flatten to add tension to the joint, counteracting fatigue around the joint from small amounts of vibration.
Keep tension when fastening materials prone to expanding and contracting, such as wood. The coil of these washers prevents nuts and bolts from loosening.
Create a stronger seal than metal or rubber alone. These one-piece washers are metal for strength with a bonded rubber seal that creates a tight grip.
Commonly called beveled washers, these are tapered to fit inside an I-beam's flange to provide a parallel bearing surface.
Commonly called beveled washers, these metric washers are tapered to fit inside an I-beam's flange to provide a parallel bearing surface.
A spring plus serrated grooves that grip the lip of the channel provide a more secure hold than standard strut channel nuts.
Use with hex nuts to connect threaded rod.
Notches on these washers grip the channel to keep them in place.
Keep hardware centered in the strut channel slot.
Add hardware to strut channel without having to hold the washer in place or reach inside the channel.